These 90 degree lower fittings have been specially made with an extra 10mm of thread both sides for more adjustment and clearance, allowing them to be wound further down into the top of the carb for even more clearance under the frame. When fully wound down this fitting only requires 22mm of space above the carb.
This 90 degree adjuster threads into the top cover and replaces the stock adjuster on our Mikuni VM and TM carburetors (excluding TM24) and is set in position using the lock nut. The OEM top rubber cap can be relocated to the new adjuster on all our VM and TM carbs excluding the TMX and TM38 models where this fitting can also be purchased with a new rubber boot.
This throttle cable adjuster fits all factory aftermarket and racing division Mikuni TM and VM carbs with a carb top hole thread pitch of 6M x 0.75
Mikuni TM and VM carbs fitted OEM to many motorcycles may have a different thread diameter than 6mm and or no threaded at all. Please check you carbs compatibility before ordering.