Cable, Mikuni VM & TM carbs- Norton MK3 Commando & Triumph T140E

$44.00 AUD

or 4 fortnightly payments of $11.00 AUD with Afterpay More info

In stock


This Mikuni throttle cable is for use on 1975 Norton Command MK3 and 1979 and later Triumph T140E stock throttle assemblies (made in France) with the 6mm top fitting, when fitting single Mikuni VM carbs ranging from 30mm up to 38mm & all TM non pump Mikuni carburetors 36mm thru to 41mm.

The exposed inner wire length is matched for use in Mikuni VM carbs using keyhole type cable attachment to the throttle valve. If your motorcycle has an OEM Japanese Motorcycle VM carb version (which normally never run properly on 4 strokes), fitted with a cable holder that is screwed to the slide, this cables use is restricted to carb sizes of 36mm and larger.

The outer cable from the carb top adjuster to the throttle measures 1020mm. This length can be sold shorter on request.

These premium grade cables use a Nylon lined outer housing. The Nylon liner inside the outer cable housing conduit is for reduced friction and heat resistance.

All throttle cables must be lubricated during installation with cable lube or a very light oil such as 3 in 1 to avoid clogging. Besides the need to lubricate the inner wire in the housing, the cable end barrels at their pivot points should be lubricated with a light water proof grease.
If you need to clean your cable which is particularly relevant for dirt bikes. We recommend using WD40 or a very light oil such as 3 in 1. This effectively washes away dirt from the cable, without clogging it.



There are no reviews yet.

Be the first to review “Cable, Mikuni VM & TM carbs- Norton MK3 Commando & Triumph T140E”

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.