Honda CB250, CB350, CB450 2-1 Cable Kit for Mikuni VM & TM carbs

$66.00 AUD

or 4 payments of $16.50 AUD with Afterpay

Description

This 2 into 1 cable assembly is for use on Honda CB250, CB350, CB400 and CB450 Twins models using the OEM throttle when fitting Mikuni VM carbs ranging from VM30 through to VM38 and all TM non pump Mikuni carburetors over 32mm.

These cables come at a set outer housing (including fittings) length of 950mm, being from the throttle inlet to the carburetor top, center. There is no extra charge if wanting this length changed to any shorter length through to a maximum of 1150mm. Please advise in your invoice notes if requiring a change or contact the office by phone on 0747712677

These premium grade cables use a Nylon lined outer housing. The Nylon liner inside the outer cable housing conduit is for reduced friction and heat resistance. They are supplied with shortened 70 degree lower cable end fittings for better petcock clearance, an inline adjuster on the top cable and a chrome OEM type top fitting for attachment to the stock Honda CB Twin throttle housing.

All throttle cables must be lubricated during installation with cable lube or a very light oil such as 3 in 1 to avoid clogging. Besides the need to lubricate the inner wire in the housing, the cable end barrels at their pivot points should be lubricated with water proof grease.
If you need to clean your cable which is particularly relevant for dirt bikes. We recommend using WD40 or a very light oil such as 3 in 1. This effectively washes away dirt from the cable, without clogging it.

 

Reviews

There are no reviews yet.

Be the first to review “Honda CB250, CB350, CB450 2-1 Cable Kit for Mikuni VM & TM carbs”

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

FREE INTERNATIONAL SHIPPING ON ORDERS OVER $500 AUD Dismiss